Little Green Man Prototype Build, Part 1, Fins

This build will show the steps (and changes) made in a kit prototype build -  of the new Little Green Man.

The fins have a complex shape, both inside and outside curves.
This is old school, no laser cutting until it becomes a kit.
All the sides were cut square and rounded edges will be shaped using dowels and files.
This isn't even all the balsa, I realized I forgot to cut two pieces after the picture was taken.

The patterns were printed on 110 lb. card stock and cut out on the outside lines.
The like, rough cut balsa pieces were stacked and sanded using the pattern piece as an edge guide.
These two pieces are the easiest to gang sand.

Here's the first two pieces ready for filling.
No, they are not the same size.