Little Green Man Prototype Build, Part 4, Fin Revision and Balsa Laser Layout

The larger lower fins needed some subtle shape change.
For two reasons - 
1. More strength after seeing the balsa grain ended up and
2. A better angle for less drag with the "T" foot piece glued to the outside edge.

The original fin is on top, the revised fin is under it.

Here's the revised upper and lower fins.
The fins were photographed with the 1" length for reference.
I can drop the jpeg picture into Corel Draw, size it to the 1" reference line and trace the new shapes.

Looking ahead, I wanted to see how all the balsa would fit on a 3" or 4" widths of balsa sheet for laser cutting.
The top picture shows the pieces set on a 4" width. The length was 7 1/4".

It's like a puzzle. Laying out the pieces takes many tries.
Using cut balsa you can see the correct grain direction.
The pieces have to be spaced so the laser cuts can't overlap.
I ended up fitting them all onto a 3" X 9" area.
On a 36" long balsa sheet I can cut four sets of fins.