Little Green Man Prototype Build, Part 7, Nose Weight and Nose Plug Assembly

The screw eye is turned into the nose plug circle until the thread line is almost gone.
A glue fillet is added to both sides.

The clay is pressed into the drilled center of the nose cone.
Look inside the nose cone and you can see the glue line around the edge for the plug and screw eye.

Press the plug into the hole and into the glue line.
Recess the plug inside the hole to allow for an additional fillet around the edge.

Looking ahead - 

I found an old can of Key Lime Rustoleum Painter's Touch. This is an old label before the 2X was added. This same can has got a lot of use over the past few years. It was used on the Franken Goblin and Elevate 11 models.
There is plenty of paint in the can, a perfect color for the project.