Little Green Man Prototype Build, Part 10, Big Mouth and Eyes

The mouth decal is tall. Before soaking, it's best to pre-cut in two at the small tic marks printed to the side of the decal. The decal separates at the nose cone and body tube joint.

When designing a possible kit, many changes are made in the prototype before the kit design is finalized.
The decal cut joint ended up about 1/8" lower than I had first drawn up.

EDIT: On this first prototype build, I set the lower half of the mouth first. It is actually easier to align both pieces setting down the upper, smaller half of the mouth first.
The lower half of the mouth is positioned first, centered below the eyes and up against the end of the body tube.
I'm tempted to say: "Bwa-ha-ha-ha!
The big mouth is a focal point of the whole design.

The eye covers were cut out of 110 lb. printed card stock and set in place with a glue stick.
Even the glue stick gives a strong hold one the eyes, even over the green paint.