Flare / Bell Bottom Build, Part 2 Design Process

Here's the back view with the shroud over a 5/60 centering ring.
There's no engine hook, the engine is slid in place and gets a wrap of masking tape over the BT-5 tube.

The extended shroud isn't as strong as I would like.

Below the centering ring I'm adding a short "nested" shroud.
This will but up against the centering ring and be even with the back end of the outside shroud.

The entire model was dry fitted to see the finished shape.
I'll probably keep the launch lug short, right beneath the hole in the shroud. It's never easy to trim the lug end even with the angle of the shroud.