Little Green Man Decals

I'm just starting to get good flight reports from the Little Green Man kits.

If you've built the kit, you know I include some extra decals.
Some builders have problems with water slide decals. The extras are there just in case.

Here's some decal tips -
1. Always wet the model surface where the decal will be placed. That gives you a wet surface under the decal allowing you more time to slide and adjust it to the final position.
2. Soak until the decals easily slide off the backing paper. I'll usually soak the decal in water for about 20 seconds, remove it from the water and let it set on a paper towel until I need it.
3. Soak and apply each decal separately!
4. Slide just a small part off the backing, place that small exposed part on the model. Hold that end on the model and slide the backing off under the decal leaving just the decal on the model.
5. A wet Q-tip makes a great tool for rolling out air bubbles under the decal.
6. In the upper left corner of the decal sheet is the kit name and decal copy. Before using a large model decal, try transferring that word block onto the model.
You can get an idea of the soak time, how the decal slides off the backing and transfers onto the model. Just remember to remove that "test" decal.
It's good practice and you won't waste a kit decal!

The idea of including extras comes from FlisKits. Jim Flis will typically include an extra shroud.
Shrouds are sometimes hard to get right, the extra gives you a second chance for a better fit.